Filter Has Run Dry After Emptying Skimmer Box
by Bob
How do I get water running through pipes again? Thanks for the question Bob There is probably a couple of things you can check. First, the gasket/O-ring on the lid might be broken or worn. If it is, you need to replace it. A broken gasket won't give you a good seal and will allow air into the system. 2nd, you'll need to prime the system. This is very simple. Be sure that no debris is in the pot. Get a bucket of pool water and pour it into the pump. It should fill with water. Put the lid back on, start the pump motor, and bleed out the air through the filter. If it doesn't fill, or if water is draining out, you can try the next step, but you need to be very careful, and quick. Partially close the bottom drain or skimmer valve, or both. This will not allow water back through the system. Fill the pump with water, put the lid on, and start your system up. Quickly open both the skimmer and bottom drain valve, then bleed the air out. I would try the first and second step before trying the third. Only do this when the other two fail. Also check the impeller in the motor house. It should turn freely. Turn off the system before checking anything. Be sure the motor is good as well. Hope this helps and have a great swimming season. Robert |
